Risk Assessment

Laboratory risk assessment for work at the Nanotechnology Research Center. Complete it before starting any laboratory work.

Checklist, safety shield, flask and nanostructure illustration

NANOTECHNOLOGY RESEARCH CENTER

Ready to work at NRC?

Project approved? Take the next step.

Complete and submit your risk assessment before starting laboratory work.

Begin work only after your risk assessment is reviewed and approved.

Download the form ↓ Plan safely. Research confidently.

BEFORE YOU START What you need An approved project or supervisor / PI Safety Data Sheets (SDS) for all chemicals Training on the relevant equipment SOP The PPE you will use (gloves, goggles, lab coat) A waste route and spill response plan Questions? nrc@squ.edu.om
+968 2414 3763

How it works

1 Download the form Download the Word form using the button above or below.

2 Complete the hazard table List each work step, its hazards, the risk before and after controls, and who is responsible. Use N/A where needed.

3 Sign and upload Your Supervisor / PI signs the form. Upload it (Word or PDF) using the form at the bottom of this page.

4 Get approval, then start The NRC reviews your assessment and contacts you. Begin laboratory work only after approval.

Submit your risk assessment

Upload your completed and signed form. It is sent to the NRC for review. Do not start laboratory work until you receive approval.

Laboratory Risk Assessment FormWord document · hazard table, checks and signatures Download ↓

Before you upload, check that: All sections and the hazard table are complete Your Supervisor / PI has signed the form The file is Word (.docx) or PDF

Your details and file

What happens next? The NRC reviews your assessment and contacts you by email. Questions: nrc@squ.edu.om · +968 2414 3763

Contact the Center

✉Emailnrc@squ.edu.om

☎Phone+968 2414 3763